TruPulse 200B to PPC GeoXT
---------------------------

1. Power up the TruPulse and turn BT On.

2. Power up GeoXT and navigate to Start / Settings / Connections / Bluetooth.

3. On the Mode tab, check Discoverable.

4. On the Bonded Devices tab, tap on New... and the TruPulse will be discovered. Tap on it's name and choose Finish. Tap Next, enter the PIN: 1111 and tap Next again. Accept the default name and tap Finish.

5. On the Serial Ports tab, tap New... under Client Serial Ports. Select the TruPulse by tapping on the name and choose Next. Choose BSP2 as the Port and tap Finish. Tap OK in the upper right conrer to close the Bluetooth Connections routine.

6. Tap the X in the upper right corner to close the Connections folder and Start the TerraSync application. Navigate to the Setup Menu and select External Sensors.

7. Under Properties for Laser set the Port to BSP2 and the Baud Rate to 4800. Tap OK. Check the box to the left of Laser and tap OK.

8. Navigate to the Data tab and open a file. Enter the Height difference between the bottom of the GPS antenna and the laser sighting scope - negative value if it is below.
*Note: at this point TerraSync will want to connect to the TruPulse. If you get an error saying the laser port failed to open, go back to the Bluetooth Connections screen and make sure the Mode is Discoverable. You may also have to Bond with the laser again when opeing a Data file and re-enter the PIN.

9. Create a feature and enter the data collection screen. If a Range/Az offset is desired, fire the TruPulse and the distance will automatically come through. Enter the Az value and tap OK.

10. If a different Offset method is desired, from the data collection screen tap Options / Offset and select it from the list. Follow the instructions to perform the measurements.